Top 10 common forklift mishaps ， forklift operation must focus on these issues ！.

Top 10 common forklift mishaps ， forklift operation must focus on these issues ！.

Blog Article

Do not undervalue the forklift at work. If the operation is not good, there will be severe mishaps in mins, and there are several crashes entailing forklifts.

Instance 1: The forklift freight obstructed the driver's sight, and the person ahead can not be located, causing a moving crash.
Instance 2: In order to keep the equilibrium of the forklift when lifting hefty items, the staff members used their body weight as the counterweight, which practically caused casualties.
Situation 3: The width of the forklift cargo exceeds the allowed size of the course and holds on the roadside shelf, which practically causes an crash.
Instance 4: Forklift is speeding up and rolls over during a turn.
Instance 5: The forklift vehicle driver did not see the pedestrian, and the pedestrian did not observe the forklift.
Situation 6: The forklift lifts the personnel unlawfully, the forklift motorist does not wear the seat belt, the forklift lifter drops and the chauffeur is crushed when the forklift surrender.
Situation 7: The forklift chauffeur did not put on a seat belt and dropped from the automobile when it rolled over and was squashed.
Forklift procedure ought to take note of these matters ：.

Start.
1. Prior to starting, observe the environments, and after verifying that there are no obstacles that prevent the security of driving, beep the horn first and then begin.
2. For vehicles with hydraulic ( atmospheric pressure) brakes, the brake hydraulic pressure ( atmospheric pressure) gauge have to be risk-free prior to starting.
3. When the forklift begins with a load, the vehicle driver ought to initially verify that the lots is stable and reliable.
4. The begin must be sluggish and steady.

Driving.
1. When driving, the height in between the bottom end of the fork and the ground ought to be maintained 300mm-400mm, and the pole ought to be slanted backward. .
2. Do not raise the fork expensive when driving. When entering and leaving the work website or while driving, beware that there will be no challenges overhead. When the load is traveling, the fork has to not be increased expensive, which will affect the security of the forklift. .
3. After dumping, the fork should be reduced to the typical driving placement before driving. .
4. When turning, if there are pedestrians or automobiles close by, the driving signal should be issued first. High-speed doglegs are banned. High-speed sharp turns will trigger the automobile to shed side security and tip over. .
5. When the forklift is downhill, it is strictly forbidden to shut off the fire and slide, and it is restricted to brake instantly while driving with loads unless there are special situations.
6. When the forklift is running, it needs to comply with the website traffic rules in the manufacturing facility and must keep a certain safety distance from the car in front. .
7. When the forklift is running, the tons needs to be in the lowest placement that does not impede the driving, and the gantry ought to be properly tilted back. The load will not be elevated except when piling or filling. .
8. The elevation of the lots need to not obstruct the chauffeur's sight. In special situations, when the thing influences the forward vision, drive at a reduced rate when reversing.
9. It is forbidden to turn on the ramp, nor to drive across the ramp. .
10. The secure driving rate of the forklift in the manufacturing facility area is 5 km/h, and it should drive safely at a reduced rate when entering the manufacturing workshop area. .
11. When the forklift is lifted, raised or driven, it is restricted for personnel to depend on the fork to hold items and play a balancing duty. .
12. If troubles are found, they will be fixed and reported in a prompt manner, and they will certainly never operate with health problems or conceal them.

packing and unloading.
1. When fork-loading items, the range between both forks ought to be adjusted as needed to make the load of both forks well balanced and not manipulated, and one side of the product need to protest the shelf. .
2. It is restricted to work with a single fork or use a fork top or draw. In special scenarios, safety indication should be established to remind surrounding pedestrians. .
3. In the process of filling and unloading products, the forklift needs to be braked with the brake. .
4. The speed of the lorry must be slow-moving and steady. Be careful not to roll the wheels on the dunnage, so as not to extend the rolled things and hurt people. .
5. When utilizing a fork to fork the goods, the fork ought to be as deep as feasible under the load, and it ought to be noted that the fork suggestion ought to not touch various other goods or items. The load must be stabilized with minimal back tilt of the gantry to ensure that the load does not move backwards. The mast can be tilted ahead slightly when the tons is decreased to enable easy placement of the lots and extraction of the forks. .
6. It is forbidden to fork goods at high speed and collide with difficult objects with the fork head. .
7. When the forklift is functioning, it is prohibited for individuals to loaf the fork, so as to avoid the collapse of the goods and hurt individuals. .
8. Straining is forbidden, and it is forbidden to utilize forks to raise employees to engage in high-altitude procedures to prevent high-altitude dropping mishaps. .
9. It is not permitted to utilize the brake inertia to slip, put, round or roll items. .
10. It is not enabled to utilize forks to choose, turn pallet unload.

Leaving .
1. It is prohibited to leave the forklift when the items on the fork impend. Before leaving the forklift, you should dump the goods or reduced the fork framework.
2. Draw the hand brake deal with to dead or depress the parking brake switch.
3. The engine is turned off and the power is cut off. (Except for special circumstances, such as the driver does not leave the car's line of sight and does not exceed 1 minute).
4. Remove the secret. .

Forklift Operation Precautions.
1. Before and after the forklift operation, the appearance should be examined, and gas, lubing oil and cooling water ought to be included.
2. Examine the safety and security efficiency of beginning, running and braking.
3. Examine whether the lights and horn signals are full and efficient.
4. During the procedure of the forklift, inspect whether the stress and temperature level are typical.
5. After the forklift is running, the external leak needs to likewise be checked and the seals need to be replaced in time.

Forklift Safety Operation Specifications.
1. You have to inspect before leaving the vehicle;.
2. When you come across a person in front of you during driving, you need to send out a signal at a distance of 5 m;.
3. The driving speed in the factory does not go beyond 5 km/h;.
4. When driving, the nadir Electric Forklift Truck for Warehouse of the cargo ought to be 0.3 m ~ 0.4 m above the ground;.
5. The transforming ought to not be too sharp to stop the tendency of "free switching";.
6. Adding and down the incline ought to be slow-moving and consistent, and no switching on the slope is enabled.
7. Do not drive throughout the slope. When the gradient is Electric Forklift Truck for Warehouse greater than 10%, the automobile ought to be driven in reverse when going downhill;.
8. When the forklift personnel bring the goods and progress, if they encounter huge or heavy products and most likely to the vehicle driver's line of sight, they should take the reversing exercise
.
The "Eight Prohibitions" ought to be followed in the procedure.
1. Solitary fork operation is not enabled.
2. It is not permitted to lift the goods for far away driving.
3. It is not permitted to pick up the goods by handing over the pallet with the fork.
4. It is not allowed to directly shovel chemicals, flammables and various other hazardous chemicals with forks.
5. It is not enabled to make use of inertia pressure to pick up the goods.
6. It is not allowed to make use of stopping pressure to expatriation round or easy-to-roll items.
7. It is not permitted to bring people to deal with the pallet or fork, and it is purely restricted to stand under the fork after the fork is raised.
8. Do not drive side to side on slopes
.
Auto parking is not permitted under the following conditions.
1. Curves, slim roads, train crossings;.
2. Areas with a longitudinal slope more than 5%.
3. When there is an barrier on one side of the road, the contrary side of the section with the exact same length as the challenge should be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：info2@onen.cn
Phone：+86 13827083844